Advertisement
Edelbrock periodically releases improved versions of the calibration file found on the supplied
handheld programmer. Check the website to ensure you have the latest version, as described in
It is also recommended that you check the Edelbrock Tech Center Website for any updates to this
installation manual. Please refer to the lower right hand footer to verify that you have the latest
revision of this installation manual before beginning the installation.
Tech Center: http://www.edelbrock.com/automotive_new/misc/tech_center/install/index.php
The supercharger has been pre-drilled and tapped for a 1/8" NPT fitting at the rear of the driver side and front
of the passenger side intake runner flange. These provisions will accommodate the installation of a boost gauge
or pressure transducer (both not included). The supercharger is shipped with plugs to seal the provisions, these
plugs can be removed, and replaced with fittings to adapt to your sensors (not included).
CAUTION: Never cut into the vacuum lines leading to the bypass actuator, on the driver's side of the manifold,
for the purpose of tapping in a boost gauge, as this will result in boost pressure readings that are higher than
what is actually present in the intake plenum.
Do not use a wideband oxygen sensor in place of the rear O2 sensor when dyno testing this
supercharger system. The voltage signal will cause the fuel system to run lean and possible
This vehicle is equipped from the factory with a wideband oxygen sensor which can be monitored
©2017 Edelbrock LLC
Part #1584, 15840
IMPORTANT WARNINGS (CONTINUE)
using the supplied handheld programmer (1584 kits only).
91 octane or higher gasoline is required at all times. If your vehicle has
been filled with anything less, it must be run until almost dry and refilled
with 91 or higher octane gasoline twice prior to installation.
Failure to use the required 91 octane gasoline or higher could permanently
damage your engine. Any failures associated with not using premium 91
octane gasoline or higher, will be ineligible for warranty repairs.
Step #108.
damage the engine.
Page 4
Edelbrock Supercharger System
2011-2014 Ford F-150 5.0L
Installation Instructions
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
