Advertisement
76. Using a 10mm socket, remove the 2nd and 3rd front
outer bolt from the passenger side valve cover. Remove the
rubber grommet from the two bolts.
77. Insert the spacers from Bag #3 into the rubber grommets
and install the recovery tank bracket onto the valve cover
using the rubber grommets and two (2) M6 x 55mm bolts
from Bag #3. Torque bolts to 8 ft-lbs.
Red bracket shown for photo purposes only.
78. Install the manifold to recovery tank hose using two (2)
3/4" hose clamps from bag #3.
©2017 Edelbrock LLC
Part #1584, 15840
Edelbrock Supercharger System
79. Using a Sharpie or equivalent, mark the current location
of the hood latch. Remove two (2) hood latch bolts using a
10mm socket and loosely mount the upper LTR (Low Temp
Radiator) bracket to the front of the hood latch as shown.
80. Using two (2) M6 x 10mm bolts from bag #3, attach the
lower passenger side LTR bracket (small bracket with four
(4) bolt holes) to the water pump bracket. Using a 21mm
socket, remove the nut from the passenger side crash
beam. Using a 10mm socket, remove the passenger side
bumper reinforcement bolt.
bracket assembly onto the crash beam stud and align with
the bumper reinforcement provision. Secure the bracket
assembly using the factory crash beam nut and the factory
bumper reinforcement bolt. Now install the driver side LTR
bracket by removing the driver side bumper reinforcement
bolt and secure the driver side LTR bracket using the factory
bumper reinforcement bolt.
Water Pump
Bracket
Crash Beam Nut
Page 19
2011-2014 Ford F-150 5.0L
Installation Instructions
Position the water pump
Pass Side
LTR Bracket
Reinforcement Bolts
M6 x 10mm
Driver Side
LTR Bracket
Bumper
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
