Advertisement
53. Verify that all O-rings are properly seated before
WARNING:
proceeding.
improperly seated O-rings will result in vacuum leaks.
54. Apply Blue Loctite to the threads of the two (2) M6 x
30mm bolts from bag #1. Using a 1/4" drive extension and
10mm socket, loosely install the bolts into the top provisions
located in between the manifold runners. DO NOT force
the bolts in and DO NOT use power tools as this may
strip the threads on the runners.
55. Apply Blue Loctite to the threads on the two (2) M6 x
16mm Socket Head bolts from bag #1 and two (2) M6 x
17mm shoulder bolts removed from Step 45. Using a 5mm
Hex tool, loosely install the 16mm bolts into the bottom
center provisions on the runner flanges. Using a 4mm Hex
tool, loosely install the 17mm shoulder bolts into the four (4)
corners of the runner flange.
56. Verify that the driver side runner is flush with the
manifold and that the o-rings are not pinched.
57. Repeat Step 51-56 to install the passenger side runner.
58. Tighten the inner manifold/runner bolts to 8 ft/lbs. Then
tighten the outer manifold/runner bolts to 8 ft-lbs. DO NOT
overtighten bolts as they may strip the threads.
©2017 Edelbrock LLC
Part #1584, 15840
This is very important as
M6 x 30mm
Hex Head
M6 x 16mm
Socket Head
M6 x 17mm
Shoulder Bolt
Edelbrock Supercharger System
59. Use a 10mm socket to install ten (10) M6 x 30mm bolts
supplied in hardware bag #1. Then torque them to 8 ft-lbs
in the sequence shown below.
60. Reinstall the actuator onto the actuator shaft by rotating
the bypass lever counter-clockwise to align the notch on the
rod with the keyhole. DO NOT bolt actuator onto the
manifold.
61. Apply O-ring lube to the supplied fuel fitting O-rings and
install them onto the supplied fittings (if not already done
so). Kit includes three (3) -6 Black Plugs, two (2) short -6
Black 180° fitting and one (1) long -6 Black 180° fitting.
NOTE: Fuel rails are identical. Passenger and driver side
will differ once the fittings have been installed.
62. Install two (2) -6 Black Plugs into both ends of the
passenger side rail and one (1) short -6 Black 180° fitting to
the bottom center of the fuel rail. The bottom center fitting
must face inwards (towards the manifold) once the rail is
installed.
Page 16
2011-2014 Ford F-150 5.0L
Installation Instructions
Passenger Side
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
