Download Print this page

Edelbrock 1584 Installation Instructions Manual page 25

E-force supercharger 2011-2014 ford f-150 5.0l

Advertisement

Edelbrock Supercharger System
2011-2014 Ford F-150 5.0L
Installation Instructions
E-mail Edelbrock Your Stock Vehicle Calibration
In the rare occurrence that you encounter an error message that reads "Calibration not supported" during
the test flash procedure on page 8, you will need to e-mail Edlecbrock your stock vehicle calibration to
Calibration@edelbrock.com. Otherwise, disregard this step.
• Begin by downloading the SCT device updater software to your computer; it can be downloaded from: http://www.
sctflash.com/software/SCTDeviceUpdater.exe
• Put the car into Acc mode but do not start it.
• Connect the supplied PCM cable from the tuner to the OBD-II connector.
Select PROGRAM VEHICLE, arrow over to UPLOAD STOCK, press SELECT and follow the prompts on the
screen.
• If the upload fails, you will be asked to AUTO DETECT, press SELECT and follow the prompts on the screen. If the auto
detect fail, then please contact Edelbrock Tech support @ 800-416-8628
• Once the stock calibration has loaded, disconnect the programmer from the OBD-II connector and connect it to your PC
using the supplied USB cable.
• Open the SCT software and select the button on the lower left hand side that reads GET STOCK FILE FROM DEVICE.
Follow the instructions on the screen.
• Once the download is complete e-mail your stock calibration to Calibration@edelbrock.com, or call 1-800-416-8628
and our tech support staff will assist you in e-mailing the file.
NOTE: The subject line of your e-mail should be "file update needed", The file will automatically be labeled using your
VIN # followed by ".sul " (XXXXXXXXXXXXX.sul)
• Once we have this file we can update the tune to work with your application, then we will e- mail you the custom tune
which you may use until the release version is available. (This process can usually be completed within 1 to 2 business
days)
• Download the new tune to the programmer using the directions received with the custom tune.
• Re-try the test flash procedure using the custom tune.
Brochure #63-1584
©2017 Edelbrock LLC
Rev. 12/11/17 - NP
Page 25
Part #1584, 15840

Advertisement

loading

This manual is also suitable for:

15840