Download Print this page

Tools And Supplies Required - Edelbrock 1584 Installation Instructions Manual

E-force supercharger 2011-2014 ford f-150 5.0l

Advertisement

Thank you for purchasing the Edelbrock Supercharger System for the 2011-2014 Ford F-150 with Coyote 5.0L Engine.
This Edelbrock E-Force Supercharger System utilizes Eaton's Gen VI R2300 TVS Supercharger rotors featuring a four lobe
design with a full 160° of twist for maximum flow, minimum temperature rise, quiet operation and the reliability for which
Eaton is known. The rotors however, are merely the foundation of the system. The Edelbrock Supercharger is a complete
system that maximizes efficiency and performance by minimizing air restriction into, and out of, the supercharger. In
addition, Edelbrock inverted the supercharger and packaged it down low in the valley allowing for an incredible 15 inches
of runner length to maximize part throttle low end torque. The supercharger housing itself is integrated into the intake
manifold for a seamless design with minimal components. The system also utilizes a front drive, front inlet configuration
giving it the shortest inlet path on the market. Sitting right above the supercharger and below the runners is a large, air
to water intercooler measuring in at 110 square inches. In summation, the Edelbrock supercharger will provide you with
incredible power that is safe to operate on a completely stock engine. It is also 50 state emissions legal when used with
the Edelbrock calibration.
l Service Lift or Equivalent
l Ratchet and Socket Set: 8mm, 10mm, 12mm,
13mm, 15mm, 17mm, 21mm (Standard and Deep)
l Allen Sockets/Wrenches: 4mm, 5mm, 6mm
l Wrench: 19mm, 22mm
l Breaker Bar: 3/8"
l Flathead and Phillips Screwdriver
l Hose Clamp Plier or Equivalent
l Pliers
l 10mm Swivel Socket
l .034" Feeler Gauge
l Shop-Vac
©2017 Edelbrock LLC
Part #1584, 15840
INTRODUCTION

TOOLS AND SUPPLIES REQUIRED

Edelbrock LLC, 2700 California Street, Torrance, CA 90503
Toll-Free Tech Line: 1-800-416-8628
Edelbrock Supercharger System
l Dremel w/ Cutoff Wheel or Equivalent
l 90° Drill
l Razor Blade or Equivalent
l Blue Loctite or Equivalent
l O-ring Lube
l 50/50 Coolant Mixture
l Masking Tape
l Torque Wrench
l Shop Rags
l Wire Ties
l Drain Pan
Page 2
2011-2014 Ford F-150 5.0L
Installation Instructions
Brochure #63-1584
Rev. 12/11/17 - NP

Advertisement

loading

This manual is also suitable for:

15840