Advertisement
95. Using two (2) 1/2" hose clamps from bag #1, install the
5" hose with protected sleeve (blue) onto the .5" fitting on
the manifold. Then install the hose onto the aspirator on the
end next to the capped barb. Attach the supplied 90°
aspirator hose (orange) to the intake elbow and then to the
aspirator port below the factory hose (purple) barb.
To Manifold
96. Route the previously installed ACT harness from the back
of the manifold, along side the driver side of the manifold,
over towards the intake elbow.
97. Connect the female MAF adaptor on the ACT harness to
the factory male MAF connector (green arrow). Connect the
male MAF connector on the ACT harness to the factory MAF
sensor. Secure the ACT harness to the existing vehicle
harnesses with wire ties.
©2017 Edelbrock LLC
Part #1584, 15840
Factory Brake
Booster Hose
To Elbow
Edelbrock Supercharger System
98. Remove the electrical tape wrapped around the factory
throttle body connector and straighten the bent harness.
Connect the supplied throttle body extension harness to the
factory throttle body connector and to the throttle body
sensor.
99. Using an 8mm (10mm on some vehicles) socket, mount
the relay and fuse holder on the water pump harness to the
stud located on the firewall harness cover. Now mount the
GROUND (-) lead to the chassis ground on the firewall.
100.
Route POSITIVE (+) lead on the water pump harness
over towards the positive terminal of the battery and install
using a 8mm socket (10mm on some vehicles).
Page 22
2011-2014 Ford F-150 5.0L
Installation Instructions
GROUND
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
