Advertisement
116. Use directional pad to highlight Begin Program then
press Select.
117. Depending on your specific drivetrain configuration,
several separate operations may take place during this step.
Completion of each operation will cause the progress bar to
reset to zero.
DO NOT unplug the programmer until prompted.
118. Turn the vehicle off when prompted to do so by the
handheld programmer.
119. Read parting message from programmer then press
Select to continue.
120. Unplug the programmer cable from the OBD-II port.
121. If you have access to a diagnostic scan tool, run a 'Key
On, Engine Off' test to verify that all connectors are properly
installed, otherwise move on to the next step.
122. Start the vehicle and verify a smooth idle. If you are
using a diagnostic scan tool, run a 'Key On, Engine Run' test.
123. Check all fluid levels before operating vehicle.
Congratulations on the installation of your new Edelbrock
E-Force Supercharger System. If you have any questions,
please call our Technical Support hotline and one of our
technicians will be happy to assist you.
©2017 Edelbrock LLC
Part #1584, 15840
Edelbrock Supercharger System
Page 24
2011-2014 Ford F-150 5.0L
Installation Instructions
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
