Advertisement
63. Install one (1) -6 Black Plug into rear of the driver side
rail, one (1) long 180° fitting onto the front of the fuel rail,
and one (1) short 180° fitting onto the bottom center
provision. The bottom center fitting must face inwards
(towards the manifold) once the rail is installed.
64. Install injector alignment brackets onto the fuel rails
using the M6 x 12mm bolts found in Bag #1. The tabs on the
bracket must face outward and away from the manifold.
NOTE: Alignment brackets on rails need to face outwards
when rails are installed.
65. Apply O-ring lube to both ends of the supplied fuel
injectors, then install them into the fuel rails, oriented so
that the electrical connectors will face away from the
manifold.
©2017 Edelbrock LLC
Part #1584, 15840
66. Position the actuator as shown and lower the driver side
fuel rail assembly onto the supercharger. Line up the fuel
injectors with their provisions on the manifold and gently
push down on the rail until the fuel injectors are fully seated.
Using a 10mm socket, install the two (2) M6 x 30mm bolts
supplied in Bag #1 to secure the fuel rail to the manifold.
Repeat Step 64-65 to install the passenger side fuel rail.
Driver Side
67. Line the actuator rod up with the mark previously made
and reinstall the actuator with the bolts previously
removed.
68. Install the supplied fuel cross over hose onto the two (2)
center fittings on the driver and passenger fuel rails.
Page 17
Edelbrock Supercharger System
2011-2014 Ford F-150 5.0L
Installation Instructions
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
