Advertisement
101. Route water pump connector down towards the water
pump and connect to the water pump. Secure the water
pump harness to the factory A/C lines with wire ties.
102. Connect the factory female EVAP connector (green
arrow) to the male EVAP connector on the water pump
harness (red arrow). Then plug the female end of the water
pump harness onto the EVAP solenoid. Secure the water
pump harness to the existing nearby harnesses with wire
ties.
103. Verify that the coolant petcock is closed, then refill the
coolant system.
104. Fill the intercooler recovery tank with a 50/50 blend
of water and coolant. Fill the tank until the water level is
roughly 1" from the top of the threaded neck.
105. Reinstall the negative battery terminal.
ignition key to the 'ON' position but DO NOT START the
vehicle.
106. Visually inspect fuel rail, fuel lines, injectors and
coolant lines for any leaks. If leaks are present, turn key
off immediately and repair leaks. If leaks are not present,
continue to the next step.
©2017 Edelbrock LLC
Part #1584, 15840
107. With the key in the "ON" position, verify that the
coolant mixture is flowing briskly through the intercooler
recovery tank. Top off coolant mixture as necessary and
install the recovery tank cap once complete.
If you have yet to flash your ECU, then proceed with
steps 108 - 120, otherwise disregard them.
108. It is recommended that you check the Edelbrock
website at: (http://www.edelbrock.com/automotive_new/
mc/superchargers/fuel_injected_soft-tech.shtml) to confirm
that you have the latest calibration. Once you have found
the latest tune on the site, power on the programmer, press
the left arrow and select the Device Info option. Scroll down
to "Tune Version" and compare that number to the one on
the site. If they are different, download the new calibration
with the supplied USB cable.
109. Put the car into ACC mode, but don't start the vehicle
110. Connect the supplied PCM cable on the handheld
programmer to the OBD-II connector located below the
steering wheel, and to the left of your knee.
111. Use directional pad to highlight Program Vehicle option
and press Select button.
112. Use directional pad to highlight Pre-programmed Tune
option and press Select button.
Turn the
113. Read disclaimer then press Select to continue.
114. Verify ignition is in the 'Key On' position but that the
engine is not running then press Select.
115. Use directional pad to highlight your vehicle and
transmission combination then press Select.
Page 23
Edelbrock Supercharger System
2011-2014 Ford F-150 5.0L
Installation Instructions
Brochure #63-1584
Rev. 12/11/17 - NP
Advertisement
