12
Introduction
ABBREVIATIONS USED IN THE MANUAL
F
Figure
T Tq
Tightening torque
P
Page
Ap
Part
S
Section
Diag
Diagram
T
Table
B
Bolt
N.B.:
The illustrations frequently show securing or adjustment bolts or screws, indicated
by the letter B. The number following this letter indicates the quantity of identical
bolts (B) or screws to be found on the unit or component being described and its
corresponding illustration. A letter without a number indicates that the quantity
is 1. In the case of different bolts or screws shown in the same figure, the B will be
followed by the number and by a lower-case letter (e.g.: (B4a)).
The refitting of units and components is normally done in this opposite way to dis-
mantling operations (except for a specific description).