FAAC MASTER-B Manual page 12

12.4.6 Speed
Press push-button P1 again and
LED E will light together with LED 2.
P2
P1
Press push-button P2, for a choice
of 4 different speeds
E1
E2
E3
P2
P1
E4
12.4.7 Simple learning
If you press push-button P1 again, all 5
LEDs from A to E will light.
(Make sure that the gate is closed and
operators locked)
P2
P1
If you press push-button P2 for 1 second,
the MASTER-B leaf and the SLAVE-B
leaf will begin to move together until
the opening mechanical stop-point is
reached. The 5 LEDs flash during this
P2 stage. After learning has been
P1
completed, the 5 LEDs remain lighted
steadily.
Press push-button P1 again to exit (all
LEDs OFF). Give a pulse with the radio
control to close the gate.
P2
P1
low
medium low (default)
medium high
high
12.4.8 Complete learning
P2
P1
P2
P1
P2
P1
25
If you press push-button P1 after setting
the speed, all 5 LEDs from A to E will
light.
(Make sure that the gate is closed and
operators locked)
If you press push-button P2 for more
than 3 seconds, leaf 1 begins to move.
You can command the following
functions with subsequent pulses from
P2 (or by key-operated push button or
radiocontrol):
1 st pulse - leaf 1 opening deceleration
starts.
Allow leaf 1 to reach its stop-point and
when it is still, leaf 2 opening movement
begins. (1)
2 nd pulse - leaf 2 opening deceleration
starts.
Allow leaf 2 to reach its stop-point and
when it is still, leaf 2 closing movement
begins. (1)
3 rd pulse - leaf 2 closing deceleration
starts and when the leaf has reached
its stop-point, the leaf 1 closing
movement begins.
4 th pulse - leaf 1 closing deceleration
starts - allow leaf 1 to reach its stop-
point.
The 5 LEDs flash during this stage.
Note (1): if you have no opening
mechanical stop-points, give the stop
command at the required point with a
further pulse from P2.
Press push-button P1 again to exit when
learning has finished (all LEDs OFF).