Specifications; Technical Specifications; Environmental Specifications - JCM GLOBAL VEGA-RC Twin Series Integration Manual

2 SPECIFICATIONS

Technical Specifications

Acceptance Denomination
Banknote Types Accepted:
Insertion Direction:
†
Processing Speed :
Diagnostic Indicators:
Drum (Stacker) Capacity:
Stacking Method:
Dispense:
*. Acceptable denomination can be selected. (Refer to "VEGA-RC Twin™ Operation Specification".)
†. Excluded host communication time lag.
‡. DO NOT replace Banknotes by hand-winding them back into place. Allow them to be replaced by the unit's recycling action only!

Environmental Specifications

Operating Temperature:
Storage Temperature:
Relative Operating Humidity:
Relative Storage Humidity:
Visible Light Sensitivity:
Installation:
*. Depends on hydrothermal conditions.
†. Do not expose to the elements (including internal parts of the unit).
Hydrothermal Condition Table
Allowable
Operating
Temperature
and Humidity Range
Temperature [ºC]
P/N 960-000169R_Rev. A {EDP #217859}
VEGA-RC Twin™ Series Banknote Recycler Integration Guide
Table 2 VEGA-RC Twin Technical Specifications
*
: Refer to the VEGA Unit's specific "Software Specification."
Long side: 110~160mm (4.33~6.3 in.)
Short side: 60~82mm (2.36~3.23 in.)
Banknote: Four-way
With VEGA Unit
Approximately 5 seconds (from Banknote insertion to stacking com-
•
pletion)
Approximately 5 seconds (from Banknote insertion to next insertion
•
enable)
Approximately 3 seconds (from Banknote dispense to eject comple-
•
tion)
Approximately 5 seconds (from receiving a retrieve command to
•
Banknote retrieved)
2 Single-color LEDs
30 Notes x 2 (150mm new Banknote - e.g., 100 Euro Banknotes)
Full detection. The number of stored notes can be set to maximum, or
between 1 and 30 notes, No Nearly Full End detection
Banknote Winding System
No denomination discrimination
No double note detection (e.g., condition is detected by the VEGA Unit)
Note length discrimination (when denomination type is set)
Table 3 VEGA-RC Twin Environmental Specifications
0ºC to +50ºC (32ºF to 122ºF)
-20ºC to +60ºC (-4ºF to 140ºF)
30% to 80% RH (non-condensed)
10% to 85% RH (non-condensed)
Avoid contact with direct sunlight
Radiant Angle of 15 Degrees or more having an Illumination index of 3000 Lux or less)
†
Indoors Only
‡
*
*
(Interior lighting must be incandescent with a
35ºC/80RH%
50ºC/30RH%
© 2012, Japan CashMachine Co., Limited
5