Functional Test Of The Safety Switches - Treif PRIMUS smart Operating Manual

Functional test of the safety switches

6.3

Functional test of the safety switches

07/2019 244156V03_EN
The blade and the product feed holder must stop instantly when you open
on of the safety covers during slicing.
WARNING
Risk of injury due to defective safety switches!
People can be injured if the machine is operated with faulty safety equip-
ment.

The machine may not be operated in the case of defective safety de-
vices, defective covers or lids, defective switches or buttons.
In this case, prevent the machine from being started up and imme-
diately arrange for repair.

Perform a function test of all safety devices daily before every
start-up.
Check the function of the safety switches after all cleaning, mainte-
nance or repair work.

Do not operate the machine if it does not switch off within the spec-
ified limits during a functional test ( "Functional test of the safety
switches" on page 41).
In this case, prevent the machine from being started up and imme-
diately arrange for repair.

Only allow TREIF Customer Service or a qualified electrician to re-
place faulty safety switches. Ensure subsequently that the gap di-
mensions have been set correctly and the safety requirements are
thus met.
Perform a function test of all safety devices daily before every start-
up.
This function is checked during the functional test described below.
1. The machine is operational.
2. Insert a product.
W_002-00
41