Fein ABOP 6 Repair Instructions page 56

ABOP 13-2
1. Fit conical sleeve to drill shaft.
2. Fit circlip to conical sleeve.
3. Fit pull-on taper on circlip.
4. Apply pressure and press down pull-on taper.
5. Check that circlip is seated correctly in the drill shaft groove.
NOTE
If the circlip isn't seated correctly in the groove, the gear changeover won't work.
All rights reserved by FEIN, especially in case of industrial rights registration.
FEIN retains all rights of disposal, such as copying and circulation.
ABOP 6, 10, 13-2
7. Assembly
C-SC_CSSM 2012.08
Tool:
-Conical sleeve and pull-on taper
64131017000
56/69 Version 1