Chevrolet Camaro 12000 1968 Series Factory Assembly Instruction Manual page 6

ASSEMBLY INSTRUCTIONS
3 9 1 8 8 5 5
1 9 6 8 C A M A R O 1 2 0 0 0 SERIES
QUANTITY
QUANTITY WHEN SHOWN, REPRESENTS FULL AMOUNT PER VEHICLE
FOR USAGE INDICATED.
QUANTITY OF STAPLES REPRESENTS NUMBER REQUIRED PER PART.
MISCELLANEOUS
SHIPPING LIST
PERTAINS TO LOOSE ITEMS SHIPPED WITH VEHICLE FROM ASSEMBLY
PLANTS-ITEMIZED IN UPC 0.
ATTACHING
PARTS
THE INSTALLATION OF ALL ATTACHING PARTS IS SHOWN IN DESIGN
POSITION & SHOULD BE ADHERED TO WHEREVER POSSIBLE. BOLT,
NUT ASSEMBLIES & STAPLES MAY BE INSTALLED FROM EITHER
DIRECTION UNLESS OTHERWISE SPECIFIED. THE TORQUE SYMBOL
IS SHOWN ADJACENT TO THE DRIVEN PART AND THE MATING
THREADED FASTENER MUST NOT MOVE DURING THE APPLICATION
OF THE SPECIFIED TORQUE.
IT IS RECOMMENDED THAT TORQUE PREVAILING LOCK NUTS BE
DRIVEN WITH AIR STALL TOOLS AT SPEEDS SLOWER THAN 350
R. P. M. THIS WILL PREVENT POSSIBLE GALLING OR DAMAGE TO
THE LOCKING FEATURES.
FLUID CARRYING
PIPES
PIPES CARRYING FLUIDS SUCH AS GASOLINE, OIL, BRAKE FLUID,
ETC., MUST BE FREE OF ALL INCLUSIONS PRIOR TO INSTALLATION.
CLEARANCE
DIMENSIONS
DIMENSIONS SHOWN ARE NOMINAL UNLESS OTHERWISE SPECIFIED.
LUBRICANT
GREASE
LUBRICATION OPERATIONS ON ALL AFFECTED PARTS (e.g*
SWIVELS, RODS, BUSHINGS, BOLTS, OR SHAFTS) MUST BE
ACCOMPLISHED PRIOR TO SUB-ASSEMBLY, EXCEPT FOR ITEMS
INCORPORATING LUBRICATION FITTINGS,.
BELT
TENSION
ALL BELT. TENSION SPECIFICATIONS ARE SHOWN IN UPC 6 ENGINE,
SPRINGS
SHOCKS
ALL SPRINGS ARE LISTED IN UPC 0 , SHOWN IN UPC 3 , FRONT
SUSPENSION & UPC 4, REAR SUSPENSION.
ALL SHOCK ABSORBERS ARE LISTED & SHOWN IN UPC 3 , FRONT
SUSPENSION & UPC 4, REAR SUSPENSION.
• OreVEOtFT MOTO* WVtSlON. G M C *
T
1
I GENERAL INFORMATION
g 12000
OWG S'iO~ £7
DATE >?,££. S
m
Z4-
A3
&/
REF: A+ L- l -
UPC
0
A4
>q SH£ET 1
pxve 49nk:
1
-