Chevrolet Camaro 12000 1968 Series Factory Assembly Instruction Manual page 308

ASSEMBLY INSTRUCTIONS
6295235
1993404
9425486
3 9 1 8 8 5 5
HARNESS ASIC
SWITCH ASIC;
SCREW
BACK-UP LAKtf>
NWTRALSAfZTY
SW/7OJTGRM/NAL
INSTALLATION PROCEDURE
1. Position column shift lever against drive
gate by rotating lower lever (part of shift
tube) counter clockwise as viewed from drivers
2 . Assemble switch asm, to column by insert-
ing "DRIVE" tang in shifter tube slot* SEE
VIEW A*
3 . Install attaching screw and torque to s p e d -
INSTALLATION IF PIN HAS BEEN SHEARED
1* Align . 0 9 3 / . 097 hole in switch asm. with
"DRIVE" tang. Insert pin to depth of .25 to
hold tang in place.
2 . Assemble switch asm. to column by inserting
"DRIVE" tang in shifter tube slot. SEE VIEW A*
3* Install attaching screws and torque to speci-
fications.
4. Remove pin.
15 - 2 5 LBS»IK.
1 9 6 8 C A M A R O 1 2 0 0 0 S E R I E S
WIRE-(Dial indicator or lamp).
1 NOTt 1 Insert terminal into open
cavity of direction signal switch
connector.
RECOMMENDED INSPECTION PROCEDURE
A. Position gear shift lever in "P" detent*
B. Turn ignition switch to "start"; starter should
operate but the vehicle must NOT move.
C. Position gear shift lever to "R" detent*
D. Move selector toward "N" to remove play, but E
NOT MOVE out of detent*
E* Turn ignition switch to "start"; starter must t*
INOPERATIVE.
F. Move selector toward "P" to remove play, but DO
NOT MOVE out of detenU
G. Turn Ignition switch to "start"; starter must be
INOPERATIVE.
H» Position gear shift lever in "N" detent,
L Turn ignition switch to "start"; starter should
operate but the vehicle must NOT move.
J. Position gear shift lever to Hi detent*
K,' Move selector toward "N" to remove play, but DO
NOT MOVE out of detent.
L
#
Turn ignition switch to "start"; starter must be
INOPERATIVE*
M«Move selector toward 1st to remove play, but DO
NOT MOVE out of detent.
N, Turn ignition switch to "start"; starter must be
INOPERATIVE.
O
#
Position gear shift lever to 1st.
P» Turn Ignition switch to "start"; starter must be
INOPERATIVE.
Q
#
Position gear shift lever to 1st detent*
R* Turn ignition switbh to "start"; starter must be
INOPERATIVE.
# a t S V 8 C U ? MO7CX OfVt&CM. GttC* UFC a*:*? r - ;<«::-csaa AUFH. M C*
T AUTO. TRANS- NEUTRAL SAFETY
i & BACK-UP LAMP SWITCH
g 12000
OWG JZ-/4
OATI AtS^. 2-/S
L- I- I-
MB1
A4
1
1
t
1G7