Chevrolet Camaro 12000 1968 Series Factory Assembly Instruction Manual page 252

ASSEMBLY INSTRUCTIONS
1 11110433
1110399
3 9 1 8 8 5 5
DISTRIBUTOR
RPOL22
1 9 6 8 C A M A R O 1 2 0 0 0 SERIES
DtSTRlB'JTOR CAP -
FORWARD
/h±D/STRl8UT0R CLAMP
DIRECTIONS FOR CONVERTING A.LR. EQUIPPED ENGINE DISTRIBUTOR TO SAME DISTRIBUTOR
AS NON A.LR, ENGINES
1. Remove distributor cap.
2. Rotate engine cranlcshaft until timing mark on torsionai damper aligns with "O" on timing
pointer and distributer rotor arm points approximately 15
C
toward the left from front of
engine. (Engine in #1 cylinder firing position).
3. Remove distributor clamp.
4. Remove distributor, Do not disturb engine crankshaft position while distributor is out of
engine.
5. Position rotor arm of distributor to point to the front of the engine and carefully slide
distributor into engine. (After installation, rotor arm will point approximately 15°
toward the left from front of engine)*
6. Rotate distributor body until the cap attaching clips form an angle of approximately 15°
counter-clockwise from rear face of engine as shown in View A.
7. Secure distributor clamp snugly.
8« With vacuum line disconnected and engine running, set timing as follows:
L-6 Eng. 4° + 1° B.T.D.C. @ 500 RPM
9. Tighten distributor clamp to specified torque*
14-18 LBS FT
1 DISTRIBUTOR CONVERSION
fc INSTRUCTIONS
g 12000 L-6 ENGINE
c/
L- I - l -
OPC
KD1
A3
I'
1
"''It ft