Chevrolet Camaro 12000 1968 Series Factory Assembly Instruction Manual page 253

III I* F I;
1
t« i I? V
ASSEMBty INSTRUCTIONS
11 1111443
1111297
1111168
3 9 1 8 8 5 5
DISTRIBUTOR
RPOL30
RPOL48
CAP
ATTACHING CUPS
1 9 6 8 C A M A R O 1 2 0 0 0 S E R I E S
A
CIAMP
DIRECTIONS FOR CONVERTING A*I*R* EQUIPPED ENGINE DISTRIBUTOR TO SAME DISTRIBUTOR
AS NON A. LR. ENGINES
1* Remove distributor cap*
2. Rotate engine crankshaft until timing mark on torsional damper aJLigns with "O
rt
on
timing pointer and distributor rotor arm points approximately 45° toward the right
from front of engine* (Engine #1 cylinder firing position)*
3* Remove distributor clamp*.
4* Remove distributor* Do not disturb engine crankshaft position while distributor is out
of engine*
5* Position rotor arm of distributor to point to the front of the engine and carefully
slide distributor into engine. (After installation,* rotor arm will point approximately
45
C
toward the right from front of engine*
6. Rotate distributor body until the cap attaching clips form an angle of approximately
15° clockwise from rear face of engine as shown in view A*
7. Secure distributor clamp snugly*
8* With vacuum line disconnected and engine running, set timing as follows:
REG* PROD 2°B.T.D*C* @ 550 R*P.M*
L30 4°B. T* D. C. @ 550 R. P*M*
L48 4°B* T*D* C* @ 550 R* P. M*
9* Tighten distributor clamp to specified torque*
/a iss rr
• CH2VTCt.1T ttOTO* DtVf&ON, C M C *
; DISTRIBUTOR CONVERSION
fc INSTRUCTIONS
g 12000 V-8 ENGINE
DWG < £ - / - £7
OAURfl &7
Cl
REF: ECA&&4& I- L-
UPC
KD1
A4