Chevrolet Camaro 12000 1968 Series Factory Assembly Instruction Manual page 334

r • & is p v - r ? V r i- v
ASSEMBLY INSTRUCTIONS
^ 9 1 8 8 5 5
PAWL
POINT O F
CONTACT (71)
1 9 6 8 C A M A R O 1 2 0 0 0 SERIES
LOADCr)
ROO(C
TRANSMISSION CONTROL LINKAGE ADJUSTMENT
1 Loosely assemble Nuts (A) & (B) on Lower Rod (C)»
2 Set Transmission Lever (D) in "DRIVE" position. INOTE1 Obtain "DRIVE" position by
moving Trans. Lever Counter clockwise to "LOW" detent, then clockwise one
detent position to "DRIVE*.*
3 Set Control Pawl Rod (E) in the
f
'NEUTRAL or DRIVE" notch of Detent (F). See
View A.
4 Apply load.in direction of Arrow (Y) on Actuating Lever (G) until pawl Rod
comes in contact with Detent at Contact Point (Z). See View A & B
5 Place a. 094Spacer (H) between Nut (A) & Swivel (J), run Nut (A) until it
touches Nut (A). Tighten Nut (B) against Swivel & lock Swivel between Nuts (A)
&(B). See View B.
The foregoing procedure will provide a . G5 over travel gap in the notches of
Detent (F).
i CM iVEC Lsi ^^OTO» IXVICiCN, GMC«
; AUTO TRANS - CONTROL CABLE
o 12000 USE WITH RPO. D55
o
-
iT
EREL 6-3 \C*
REr L-8O5SJ L-
I - L- L-
U?C
M35
A1O
OATf
7-/5-47
TfH
/
SU££f CANC£L£O
AUTH.
_
CK
I