Banner SureCross DX80 GatewayPro Series Quick Start Manual page 4

DIP Switch Settings
Device Settings
Rotary dial address mode
Extended address mode
* Default configuration
Address Mode
The SureCross wireless devices may use one of two types of addressing modes: rotary dial addressing or extended addressing. In
rotary dial address mode, the left rotary dial establishes the network ID and the right rotary dial sets the device ID. The wireless network
is restricted to a maximum of 16 devices.
Extended address mode uses a security code to "bind" Nodes to a specific Gateway. Bound Nodes can only send and receive informa-
tion from the Gateway to which they are bound. In extended address mode, wireless networks may contain up to 48 radio devices. For
more information on extended address mode, refer to the SureCross™ Wireless I/O Network product manual.
The device ships in rotary dial address mode by default, with the DIP switch in the OFF position. To use extended address mode, change
the DIP switch to the ON position.
Wiring Your SureCross® Device
Use the following wiring diagrams to first wire the sensors and then apply power to the SureCross devices.
5-pin Euro-Style Hookup
Wiring the 5-pin Euro-style connector depends on the model and power requirements of the device. Connecting dc power to the commu-
nication pins will cause permanent damage.
2
3 1
5
4
Industrial Ethernet Wiring
Use the 4-pin industrial Ethernet connection to connect the radio network to an Ethernet-based host system.
LED Behavior for the Gateways
After powering up and binding the Gateway and its Nodes, verify all devices are communicating properly. When testing communication
between the Gateway and Node, all radios and antennas should be at least two meters apart or the communications may fail.
LED 1
(solid green)
4
1
OFF*
ON
Wire No.
1
2
3
4
5
Wire No. Wire Color
1 White/Orange
2 White/Blue
3 Orange
4 Blue
LED 2
www.bannerengineering.com - tel: 763-544-3164
Switches
2
Wire Color Description
Brown 10 to 30V dc
White RS485 / D1 / B / +
Blue dc common (GND)
Black RS485 / D0 / A / –
Gray Comms Gnd
Description
+Tx
+Rx
-Tx
-Rx
Gateway Status
Power ON
SureCross DX80 GatewayPro
3 4
P/N 131933 Rev. F