Main Wing Assembly - Freewing F-86 SABRE User Manual

Main Wing Assembly

1. Use a servo tester or radio to center the
servo.
2. Use the supplied glue to secure the servo
box (E) into the servo hatch.
3. Install servo (C) into the servo box(E).
4. Use 2 screws (A) to screw the servo cover
(B) to the servo hatch (E), thus securing the
servo(C).
5. Feed the open end of the servo pushrod (D)
into the servo arm and adjust the control rod
clevis to the proper length so that at the servo's
centered position, the flap is completely
retracted.
6. Repeat these steps to install the other three
servos to the wing, remember to center the
ailerons and adjust the clevis, so that they are
centered when the clevis is attached to the
control horn and the servo is centered.
Note: all servo boxes are factory installed so if
it becomes necessary to replace a servo, it will
not damage the foam. If you need to replace a
servo and choose not to use a Freewing
product, please refer to the following diagrams
for the correct size.
=
i ; i
-
1. Use the carbon tube to connect the left
and right wings.
2. Use a Y connector to connect the left
and right flap servos.
3. Use a Y connector to connect the left
and right aileron servos.
4. Use a 3 to 1 connector to connect the
left and right main landing gear.
5. Secure the main wing to the fuselage
and feed the connectors through to the
fuselage so that they can be plugged into
the receiver.
6. Secure the wing using the plastic wing
plates (1 and 2)
F-86 Sabre
Item No.: FJ2031
Version No.: FJ2031-V01
www.modellmarkt24.ch; www.modellmarkt24.ch;
Aileron pushrod size
m � ���� � , �
7 _ 8 m
I
---- (2.7in)
:===
= = =
6
Pu hod diameter : 0 1.2mm
�
s
�
Flap pushrod size
67.8mm
(2.7in)
Pushod diameter: 01.2mm
Main wing plate1
�A PWA1.7x5
Tt
Aileron pushrod mounting hole
•• - • • --- . �
2
3
,
-
9;ji � �'.
· : g -
4 - @
i' ==
FI a p pushrod mounting hole
Carbon Tube
_ ._\ �"
__
-4-
www.modellmarkt24.de www.modellmarkt24.de
B
-- -- - -- - - - -- - 2
�
� �·;f� , E I
�3; '� �· · · · - - - - - - - - - - - - - - - -
��-
·· · ·· · · · ·· · ·· · · ·· · 1
EN
3