Page 2
The model is receiver-ready and includes everything that you need to assemble and fly your F9F Panther, except for the radio transmitter and receiver. Please read the following instructions carefully, assembly is easy and should only take an hour or so.
Page 3
6. The F9F Panther is made from EPO foam and plastic. These materials are flammable and can be damaged by high heat. Never leave your F9F Panther near a heat source or in an automobile. 7. Do not attempt to catch your F9F Panther while flying.
Page 4
90 degrees to the fin. one wing panel. 6. Apply 5-minute epoxy to the wing tabs 7. Attach and hold the wing in place until on the fuselage. the epoxy cures. Repeat for other wing. F9F Panther Item No.:F1701...
Page 5
Be sure not to foul the pushrod opening with glue. 11. Epoxy the area where the foam insert goes and carefully install the insert while making sure the elevator tube goes into the exit slot. F9F Panther Item No.:F1701...
Page 6
14. The hatch has magnets at the front and a tab at the back. Lift from the front and slide forward to remove the hatch. Install your receiver using double sided tape or Velcro. F9F Panther Item No.:F1701...
Page 7
Use 5-minute epoxy to install the plastic landing gear base. Next, feed the steering servo wire into the nose and glue the nose gear base in place. Connect the nose wheel steering lead to the rudder channel on your receiver. F9F Panther Item No.:F1701...
Page 8
19. Elevator control throws are 3/16” Up and Down on Low Rates. They are 5/16" Up and Down on High Rates. 20. The Center of Gravity for the F9F Panther is 1-3/4” (45mm) back from the leading edge F9F Panther...
Page 9
Example: right stick moved to the right and the aileron on the right wing moves upward while the aileron on the left wing moves downward. 24. Adjust each control surface to its neutral position by mechanically adjusting each clevis. Recommended control throws for F9F Panther Elevator Aileron Low Rates 3/16”...
Page 11
Have Fun! We hope that you have many pleasant flights with your F9F Panther Shenzhen Freewing Model Co.,Ltd. HK Freewing Model International Limited Tel: +86 755 2967 1969 +86 755 3323 1841 Fax:+86 755 3323 1843 freewing@sz-freewing.com...