Agilent Technologies N5230AU-974 Installation Note page 27

Reinstall the Outer Cover
This procedure is best performed with the analyzer resting on its front
CAUTION
handles in the vertical position. Do not place the analyzer on its front panel
without the handles. This will damage the front panel assemblies.
1. Slide the cover onto the frame.
2. Using a T-20 TORX driver, install the four rear panel feet (item
{
screws (item ).
3. Slide the four bottom feet (item
4. Using a T-20 TORX driver, install the strap handles (item
y
(item ) on both ends.
Figure 19 Outer Cover Reinstallation
Installation Note N5230-90022
|
) onto the cover.
z
) by installing the center
x
) by tightening the screws
27