Advertisement
eleCTROMAGNeTIC COMPATIBIlITy (eMC)
FCC Information:
This device complies with CFR47 Part 15 of FCC Rules for Class B equipment.
esTI Information (Ce):
This device meets the relevant standards set out in European Standard EN 60945:2002 for
maritime navigation and radio communication equipment and systems. These
standards are intended to provide reasonable protection against interference by other
emission generating products on the boat. Compliance with these standards is no
guarantee that interference will not occur in a particular installation. The installation
instructions must be followed to minimise the potential for interference.
Note: If shielded cable is not used for the sensor connections this will compromise the
EMC and may invalidate the warranty.
The AA150 console must be installed at least 3 ft (1m) away from any transmission
equipment or cables carrying radio signals eg VHF radios, cables and antennas or radar
antennas; and at least 6 ft (2m) away from any SSB equipment. AA150 cables must be
installed at least 1.5ft (500mm) away from such items.
1.1 TeChNICAl sPeCIFICATIONs AA150
Power Supply
12V/24V DC
Current Consumption
30mA
IP Rating
IP65 from the front provided the unit is mounted so the back is
protected from moisture.
Maximum Voltage
30V DC
Operating Temperature
23
F to 140
o
Range
Sensor
Compatible with all AutoAnchor sensors, reed switches and
some proximity switches.
Rode - Chain Only
Stainless or galvanised steel.
Rode - Rope and Chain
Must have a minimum of 10ft (3m) of chain. Chain must be
galvanised steel. Rope should be a good quality, nylon anchor
rope. Type 66 or equivalent.
DC windlasses require a dual direction solenoid
2
These
F (-5
C to 60
C)
o
o
o
1.2 CABle sPeCIFICATIONs
All Cables: 1.0mm
(AWG18)
2
Rope/Chain Connections: If the brown and white wires are connected to the motor
terminals for rope/chain counting short circuit protection is required. The load sensor
terminators supplied have motor terminal connectors with a 1000 ohm resister prefitted. If
these terminators are not used a 1000 ohm resister must be fitted near the motor terminal.
1.3 POweR suPPly
ThE PoWER SuPPly MuST BE DISCoNNECTED DuRINg INSTAllATIoN AND WhEN
MAkING ANY CHANGES TO WIRING OR ELECTRICAL CONNECTIONS.
12V or 24V DC power supply is required to the AA150 console.
Check battery polarity before connecting power.
The power must be disconnected when installing and connecting the wiring.
A 5 Amp resettable isolating/breaker switch to shut off power to the AA150 and the
windlass must be installed in a position easily accessed by the AA150 operator.
Multiple battery bank negative terminals must be permanently connected together to
become the common negative return (ground).
Power to the AA150 and all windlass controls eg. toggle switch, remote switches, deck
switches must be supplied from one point or the AutoAnchor will be damaged.
3
Advertisement
