Copying of this service manual, or part of it, is forbidden without prior written permis- sion from Dantherm A/S. Reservations Dantherm A/S reserves the right to make changes and improvements to the product and the service manual at any time without prior notice or obligation. EC-Declaration of...
Product- and functional description Introduction This section will give you a description of the CDF 35/45 and its functionality. Functional CDF 35/45 are working in accordance with the condensation principle. The humid air is description drawn into the unit by a fan. When passing through the evaporator the air is cooled down to below dew point and water vapour is condensed into water, which is drained away.
Page 5
Product- and functional description, continued Built in hygrostat, If you want to set the hygrostat lower than 60 %RH, turn the adjusting screw clockwise. continued We recommend installing an external hygrostat if you want to change/adjust the setting of relative humidity very often. Connection of Connect an external hygrostat by uncoupling the built-in hygrostat from the terminals external hygrostat...
Page 6
Product- and functional description, continued Display indications, Part Function continued Defrosting The LEDs 4 and 5 light up during defrosting of the mode – the evaporator. In defrosting mode the compressor is evaporator is working and the fan is stopped. When the evaporator being de- sensor has registered a temperature higher than 5 °C frosted...
NOTE Dantherm Air Handling recommends a minimum distance between dehumidifier and ceiling and dehumidifier and floor of 225 mm. The dimensions indicate the placing of the wall suspension bar.
Service guide Access to the CDF 35/45 CDF 35T/45T control Remove the front panel by screwing off Open the unit by removing the screws (4) two screws on top of the dehumidifier. Lift on the front of the unit, i.e. opposite to the front panel vertically upwards and the unit’s duct openings.
More help If you cannot find the reason for the fault, switch off the unit immediately in order to prevent further damage. Contact a service technician or a Dantherm representative.
Technical data General data The table shows the dehumidifier’s general technical data: CDF 35/35T CDF 45/45T Working area, humidity 60 %RF 40-100 Working area, temperature °C 3-30 Power supply V/Hz 230/50 Max. ampere consumption Max. power consumption 0.70 Air volume at max. external...
Hotline The After Sales Support Department of Dantherm A/S is ready to help you in case of a problem. To be able to offer quick and efficient help, please have the following information ready when contacting Dantherm A/S: ...
Målskitser/Dimensional outlines/Maßskizzen/Croquis coté/Schema dimensionale Model CDF 35T 387 mm 887 mm 130 x 410 mm CDF 45T 692 mm 1192 mm 130 x 720 mm Kanalåbning i muren • Duct opening in the wall • Kanalöffnung im Mauer • Ouverture de gaine dans le mur • Apertura nel muro per passaggio canali Fortsættes/continued overleaf/fortsetzt/Suite à...
Page 17
Målskitser/Dimensional outlines/Maßskizzen/Croquis coté/Schema dimensionale, continued Målene angiver placeringen af vægbeslaget The dimensions indicate the placing of the suspension bar Die Dimensionen zeigen die Plazierung der Wandkonsole an Les dimensions indiquent la position de la barre d’ancrage Le misure indicano la posizione della staffa di ancoraggio...
Reservedele/Spare parts/Ersatzteile/Pièces de rechange/Parti di ricambio Illustration CDF 35/45 1 × 230 V/50 Hz Fortsættes/continued overleaf/fortsetzt/Suite à la page suivante/continua alla pagina seguente...