Operation
Dimmer Curve
To set the dimmer curve, follow the instructions below:
1.
Go to the Dimmer Curve main level.
2.
Select the desired option (Linear, Square, I Square, or SCurve).
Dimmer Profiles
This setting determines how fast the output of the Ovation F-55WW changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, DIM1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation F-55WW.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation F-55WW's display stays
on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On (remains on).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the Information main level.
2.
Select Fixture Hours, Version, or UID.
Factory Reset
This option restores the Ovation F-55WW to factory default settings.
1.
Go to the Reset Factory main level.
2.
Select No or Yes.
Ovation F-55WW User Manual Rev. 2
Page 10 of 15