Table of Contents
Advertisement
Operation
3Ch
Channel Function
1
White
2
Amber
3
Red Shift
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Static Mode
The Static mode allows for the selection of a fixed color or a custom color without a DMX controller.
1.
Go to the Static main level.
2.
Select Fixed Color or Manual Color Mixer.
3.
For Fixed Color, select from Amber, White, or Amber&White.
For Manual Color Mixer, select Amber or White, then select the desired value (0–255).
Auto Programs
Auto programs allow for dynamic blinder effects without a DMX controller.
1.
Go to the Auto Show main level.
2.
Select the desired auto (Auto 1–6).
3.
Select the desired speed (001–100).
The auto programs cannot be edited.
Master/Slave
The Master/Slave mode allows a group of STRIKE Saber products (the slaves) to simultaneously duplicate
the output of another STRIKE Saber (the master) without a DMX controller. To set each of the slaves:
1.
Go to the Master/Slave main level.
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level.
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave operation.
The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Profiles
This setting determines how fast the output of the STRIKE Saber changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, DIM1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the STRIKE Saber.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Back Light
This setting allows for selection of the amount of time the backlight on the STRIKE Saber's display stays
on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
STRIKE Saber User Manual Rev. 1
Value
Percent/Setting
000
255 0–100%
000
255 0–100% (disabled when Red Shift is on)
000
Red Shift on, amber channel disabled
001
255 Red Shift off, amber channel enabled
Page 13 of 19
Advertisement
Table of Contents
