Table of Contents
Advertisement
O
PERATION
Master/Slave
The Master/Slave mode allows a group of Ovation E-910FC IP products (the slaves) to simultaneously
duplicate the output of another Ovation E-910FC IP (the master) without a DMX controller.
To set each of the slaves:
1.
Go to the Master/Slave main level
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave
operation. The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Profiles
This setting determines how fast the output of the Ovation E-910FC IP changes when the output value is
modified. It provides four different options to simulate the dimming curve of an incandescent lighting product.
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, Dimmer 1 being the fastest.
White Balance
This setting determines the maximum output values for each color, which affects the appearance of a full
output white.
1.
Go to the White Balance main level.
2.
Select Off (the product will use a default setting) or Manual.
3.
For Manual mode, select the color value to edit (Red, Green, Blue, Amber, or Lime).
4.
Set the maximum value for the selected color (125–255).
5.
Repeat steps 3 and 4 until the product outputs as desired.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the
Ovation E-910FC IP.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This setting determines how the fan speed on the Ovation E-910FC IP is set.
1.
Go to the Fan Mode main level
2.
Select Auto (fan speed will increase or decrease based on product temperature), Off (fan will
stay off. Product output will decrease based on product temperature), Silent (fan will maintain a
constant silent speed), or On (fan speed will always be at maximum).
NOTICE: When operating in Fan Mode: Off, the output of the fixture will be reduced
and will not reach the same levels as when using other fan modes.
WARNING: When operating in Fan Mode: Off, the fixture will become hotter to the
touch than when using other fan modes. Use proper protective equipment to prevent
burns. Keep a safe distance from flammable objects.
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation E-910FC IP's display
stays on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select 10S (10 seconds), 30S (30 seconds), 2Min (2 minutes), or Always On (remains on).
Ovation E-910FC IP User Manual Rev. 4
Page 19 of 31
Advertisement
Table of Contents
