Table of Contents
Advertisement
Configuration (Standalone)
Use standalone configuration to operate the product without a DMX controller.
Static Mode
The Static mode allows for permanent dimmer, zoom, and strobe presets without a DMX controller.
1.
Go to the Static main level.
2.
Select Dimmer, Zoom, or Strobe.
3.
Select the desired value (0–255).
Master/Slave
The Master/Slave mode allows a group of Ovation F-265WW products (the slaves) to simultaneously
duplicate the output of another Ovation F-265WW (the master) without a DMX controller.
To set each of the slaves:
1.
Go to the Master/Slave main level
2.
Select Slave.
To set the master:
1.
Go to the Master/Slave main level
2.
Select Master.
3.
Select a static setting.
•
The master is the one that runs a program whether in Auto or Static mode.
•
Do not connect a DMX controller to the products configured for Master/Slave operation.
The DMX controller may interfere with signals from the master.
•
The master should be the first product in the daisy chain.
Dimmer Profiles
This setting determines how fast the output of the Ovation F-265WW changes when you modify the output value.
This setting provides four different options to simulate the dimming curve of an incandescent lighting product.
1.
Go to the Dimmer Mode main level.
2.
Select a dimmer curve (Off, Dimmer 1, Dimmer 2, or Dimmer 3).
Off: The output is proportional (linear) to the dimmer channel value.
Dimmer 1-3: The output follows the dimmer value based on the corresponding dimmer
curve, DIM1 being the fastest.
LED Frequency
This option changes the Pulse Width Modulation (PWM) frequency of the LEDs on the Ovation F-265WW.
1.
Go to the LED Frequency main level.
2.
Select PWM Frequency (600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz, or 25Khz).
Fan Mode
This setting determines how the fan speed on the Ovation F-265WW is set.
1.
Go to the Fan Mode main level
2.
Select Auto (fan speed will increase or decrease based on product temperature), On (fan speed
will always be at maximum), or Off (fan will always be off).
NOTICE: When operating in Fan Mode: Off, output of the fixture will be reduced and
will not reach the same levels as when using other fan modes.
WARNING: When operating in Fan Mode: Off, the fixture will become hotter to the
touch than when using other fan modes. Use proper protective equipment to prevent
burns. Keep a safe distance from flammable objects.
Back Light
This setting allows for selection of the amount of time the backlight on the Ovation F-265WW's display
stays on after the last button is pressed on the control panel.
1.
Go to the Back Light main level.
2.
Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
System Information
This option displays the total number of hours the product has run, the installed software version, and the
product's UID.
1.
Go to the Information main level.
2.
Select Fixture Hours, Version, or UID.
Factory Reset
This option restores the Ovation F-265WW to factory default settings.
1.
Go to the Reset Factory main level.
2.
Select No or Yes.
Page 10 of 15
Ovation F-265WW User Manual Rev. 1
Operation
Advertisement
Table of Contents
