Installing And Adjusting The Handle - Toro Greensmaster 1000 Operator's Manual

1
Installing and Adjusting the
Handle
Parts needed for this procedure:
1 Handle
4 Cable tie
Installing the Handle
1. Remove the bolts (5/16 inch), locknuts, ring
pins, and hairpin cotters that secure the bottom
of the handle arms to each side of the machine
(Figure 3).
1. Hairpin cotter
2. Mounting pin
3. Washer
4. Lock washer
5. Bolt (3/8 inch)
2. Remove the bolts (3/8 inch), washers, and lock
washers from the mounting pins on each side of
the machine (Figure
3. Insert the handle ends through the holes in
the handle arms and align the holes with the
mounting pins (Figure
4. Squeeze the handle ends inward and install
them on the mounting pins
Figure 3
6. Locknut
7. Bolt (5/16 inch)
8. Ring pin
9. Handle arm
3).
3).
(Figure 4).
1. Handle
2. Handle arm
3. Mounting pin
5. Secure the handle to the mounting pins with the
bolts (3/8 inch), washers, and lock washers that
you previously removed
6. Use the bolts (5/16 inch), locknuts, hairpin
cotters, and ring pins that you previously
removed to secure the handle arms to the rear
of the frame
7. Secure the cables and wire harness to the
handle with the cable ties
g240399
8
Figure 4
4. Washer
5. Lock washer
6. Bolt (3/8 inch)
(Figure 4).
(Figure 3).
(Figure 5).
g240404