Setup; Installing And Adjusting The Handle - Toro Greensmaster 04052 Operator's Manual

Setup

Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Certificate of Compliance
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing and Adjusting the
Handle
Parts needed for this procedure:
1 Handle
2 Cable tie
Installing the Handle
1. Remove the bolt, washer, and lockwasher from the
mounting pin on each side of the mower (Figure 2).
Description
Handle
Cable tie
Kickstand assembly
Spring
Wheel shaft, right
Wheel shaft, left
Transport wheels (obtain separately)
No parts required
Grass basket
Qty.
1
2
1
1
1
1
2
–
1
Qty.
1
1
1 Read or view before operating the machine
1
1
1. Mounting pins
2. Handle arms
2. Remove the bolts and locknuts securing the bottom
of the handle arms to each side of the mower
(Figure 2).
3. Remove the hairpin cotters and ring pins securing
the handle arms to the rear of the frame (Figure 2).
4. Insert the handle ends thru the holes in the handle
arms and align the holes with the mounting pins
(Figure 2).
10
Use
Install the handle.
Install the kickstand (model 04035 only).
Install the transport wheels.
Adjust the cutting unit.
Install the grass basket.
Use
Figure 2
3. Bolt and locknut
4. Hairpin cotter and ring pin