Pre-Maintenance Procedures; Preparing The Machine For Maintenance; Lubrication; Greasing The Machine - Toro Greensmaster 1000 Operator's Manual

Pre-Maintenance
Procedures
Preparing the Machine for
Maintenance
WARNING
While you are maintaining or adjusting the
machine, someone could start the engine.
Accidentally starting the engine could
seriously injure you or other bystanders.
Shut off the engine, engage the parking brake,
and pull the wire(s) off the spark plug(s)
before you do any maintenance. Also push
the wire(s) aside so it does not accidentally
contact the spark plug(s).
Perform the following before servicing, cleaning, or
making any adjustments to the machine.
1. Park the machine on a level surface.
2. Shut off the engine and remove the key from the
machine (if equipped).
3. Engage the parking brake.
4. Wait for all moving parts to stop allow the engine
to cool before servicing, storing, or making
repairs.
5. Disconnect the spark-plug wire
Figure 21
1. Spark-plug wire

Lubrication

Greasing the Machine

Service Interval: Every 25 hours
Lubricate the 12 grease fittings on the mower
using No. 2 lithium grease. For best results, use a
hand-operated grease gun.
The grease fitting locations are as follows:
•
•
•
•
•
•
1.
2.
3.
(Figure 21).
g265998
25
2 on the front roller (Figure
2 on the reel bearings
2 on the drum axles (Figure
3 on the differential (Figure
2 on the reel countershaft bearings
1 on the belt idler pivots
Wipe each grease fitting with a clean rag.
Pump grease into each fitting.
Important:
Do not apply too much pressure
or the grease seals may become permanently
damaged.
Wipe off any excess grease.
Figure 22
Figure 23
22)
(Figure 22)
23)
23)
(Figure 24)
(Figure 25).
g007613
g016993