Controls - Toro Greensmaster 1000 Operator's Manual

Controls

Figure 12
1. Traction-drive lever
2. Throttle control
3. On/Off switch
4. Hour meter
Traction-Drive Lever
The traction-drive lever
front right side of the control panel. It has 2 positions:
N and F
EUTRAL ORWARD
engages the traction drive.
Throttle Control
The throttle control (Figure
right side of the control panel. The lever connects to
and operates the throttle linkage to the carburetor.
Refer to Specifications (page 14)
On/Off Switch
The On/Off switch (Figure
the control panel. Move the switch to the O
to start the engine and the O
the engine.
Service Brake
The service brake (Figure
left, front side of the control panel. You can use the
brake to slow or stop the machine.
5. Service brake
6. Parking brake
7. Operator-presence control
(optional)
(Figure 12) is located on the
. Pushing the lever forward
12) is located on the rear,
for the engine speed.
12) is located on the top of
position
N
position to shut off
FF
13) is located on the top
g017592
Parking Brake
The parking brake
the service brake. Fully engage the service brake and
push the parking-brake knob to allow the service brake
to rest on the parking-brake pin. Engage the service
brake to release the parking brake. You must release
the brake before you engage the traction drive.
Operator-Presence Control
Optional
If equipped, the operator-presence control
12) is located on the rear of the handle. Push the
operator-presence control against the handle. You
must engage, the operator-presence control before
moving the traction-drive lever. If you release the
operator-presence control, the engine shuts off.
13
Figure 13
(Figure 14) is located at the base of
Figure 14
g016976
g016977
(Figure