Toro Greensmaster 1000 Operator's Manual page 33

5. While maintaining a slight gap between the
cover seal and the side plate, install each
mounting bolt until the threads engage in the
insert. The gap allows visual alignment of the
bolts to the threaded inserts.
6. After all bolts are installed, tighten them until
the stand-offs inside the cover contact the side
plate. Do not overtighten the bolts.
Adjusting the Primary V-Belts
1. To adjust the belt tension on primary V-belts,
first check the adjustment of the traction control;
refer to Adjusting the Traction Control (page
If the belts still slip after you adjust the traction
control, proceed to the next step.
2. Loosen the retainer that secures the V-belt cover
and pivot the cover open
1. V-belt cover
3. To increase the belt tension, loosen the engine
mounting bolts and move the engine backwards
in the slots.
Important:
Do not over-tension the belt.
4. Tighten the mounting bolts.
Note:
The distance between the center of the
drive pulley and the center of the driven pulley
should be approximately 12.7 cm (5 inches)
after the new V-belts are installed.
5. After tensioning the primary V-belts, check the
alignment of the engine output-shaft pulley and
the counter-shaft pulley with a straightedge.
6. If the pulleys are misaligned, loosen the screws
that secure the engine mounting base to the
machine frame and slide the engine from side to
side until the pulleys are aligned within 0.7 mm
(0.030 inch).
7. Tighten the mounting screws and check the
alignment.
(Figure 41).
Figure 41
2. Retainer
8. To push or pull the machine easier without
starting the engine, adjust the belt guide
42, inset) as follows:
A. Engage the clutch.
B. Loosen the locknut that secures the idler
pulley and the belt guide to the idler arm.
C. Rotate the belt guide clockwise until a gap
of approximately 1.5 mm (0.06 inch) is
obtained between the guide finger and the
backside of the drive belts.
D. Tighten the locknut that secures the idler
pulley and the belt guide to the idler arm.
35).
g016991
1. Locknut
2. Belt guide
9. Close the cover and secure the retainer.
33
Figure 42
3. Idler pulley assembly
4. Idler arm
(Figure
g282596