Toro Greensmaster 1000 Operator's Manual page 32

Important:
B. Tighten the nut to lock the adjustment.
4. Install the belt cover by placing it in position.
5. While maintaining a slight gap between the cover
seal and the side plate, install each mounting
bolt until the threads engage in the insert.
Note:
The gap allows visual alignment of the
bolts to the threaded inserts.
6. After all bolts are installed, tighten them until the
stand-offs inside the cover contact the side plate.
Note:
Do not overtighten the bolts.
Adjusting the Traction-Drive Belt
1. Remove the belt-cover mounting fasteners and
the belt cover to expose the belt
1. Traction-drive-belt cover
2. Check the tension by pressing the belt at mid
span of the pulleys
(4 to 5 lb) of force.
Note:
The belt should deflect 6 mm (1/4 inch).
1. Traction-drive belt
3. Complete the following to adjust the belt tension:
Do not over-tension the belt.
(Figure
Figure 38
(Figure 39) with 18 to 22 N
Figure 39
2. Idler pulley
A. Loosen the idler-pulley mounting nut and
pivot the idler pulley clockwise against the
backside of the belt until the desired belt
tension is attained
Important:
B. Tighten the nut to lock the adjustment.
4. Install the belt cover by placing it in position.
5. While maintaining a slight gap between the cover
seal and the side plate, install each mounting
bolt until the threads engage in the insert.
Note:
bolts to the threaded inserts.
6. After all bolts are installed, tighten them until the
stand-offs inside the cover contact the side plate.
38).
Note:
Adjusting the Differential Belt
1. Remove the bolts securing the front and rear
sections of the differential cover to the differential
housing and slide the cover sections away to
expose the belt.
2. Check the tension by pressing the belt at mid
span of the pulleys
(5 to 6 lb) of force.
Note:
g007598
1. Differential belt
3. Complete the following to adjust the belt tension:
A. Loosen the idler pulley mounting nut and
pivot the idler pulley clockwise against the
backside of the belt until the desired belt
g007621
tension is attained
Important:
B. Tighten the nut to lock the adjustment.
4. Install the belt cover by placing it in position.
32
(Figure
Do not over-tension the belt.
The gap allows visual alignment of the
Do not overtighten the bolts.
(Figure 40) with 22 to 26 N
The belt should deflect 6 mm (1/4 inch).
Figure 40
2. Idler pulley
(Figure
Do not over-tension the belt.
39).
g007622
40).