Specifications; Attachments/Accessories - Toro Greensmaster 1000 Operator's Manual

Reel-Drive Lever
The reel-drive lever (Figure
front corner of the machine. The lever has 2 positions:
•
E —move the lever forward to engage the
NGAGE
reel.
•
D —move the lever rearward to
ISENGAGE
disengage the reel.
Figure 15
1. Reel-drive lever
Choke Lever
The choke lever (Figure
of the engine. Use the lever to aid in starting a cold
engine; refer to Using the Choke Lever (page
Figure 16
1. Choke lever
2. Fuel-shutoff valve
Fuel-Shutoff Valve
The fuel-shut-off valve is located on the side of the
engine below the choke control
15) is located on the right,
16) is located on the left front
18).
3. Recoil-starter handle
(Figure 16).
Note:
Close the fuel-shutoff valve when the machine
is not used for a few days, during transport to and
from the job site, or when the machine is parked
inside a building; refer to
Fuel-Shutoff Valve (page
Recoil-Starter Handle
Pull the recoil-starter handle
engine.

Specifications

Model Specifications
Width
Height
Length with basket
Dry weight (with basket and
Wiehle roller; without wheels
or grooming reel)
g016978
Width of cut
Height of cut
Clip
Engine speed

Attachments/Accessories

A selection of Toro approved attachments and
accessories is available for use with the machine
to enhance and expand its capabilities. Contact
your Authorized Service Dealer or authorized Toro
distributor or go to www.Toro.com for a list of all
approved attachments and accessories.
To ensure optimum performance and continued safety
certification of the machine, use only genuine Toro
replacement parts and accessories. Replacement
parts and accessories made by other manufacturers
could be dangerous, and such use could void the
product warranty.
g265059
14
Opening and Closing the
19).
(Figure 16) to start the
Model 04055
91 cm (36 inches)
114 cm (45 inches)
122 cm (48 inches)
98 kg (216 lb)
53 cm (21 inches)
1.6 mm to 31.8 mm (0.063
to 1.25 inches)
4.3 mm (0.16 inch)
Low idle: 1,800 to 2,000 rpm;
High idle: 3,350 to 3,550 rpm