Setup; Installing And Adjusting The Handle; Loose Parts; Installing The Handle - Toro 04038 Operator's Manual

Setup

Loose Parts

Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
6
Media and Additional Parts
Description
Operator's Manual
Engine Operator's Manual
Parts Catalog
Operator Training Material
Certificate of Compliance
Note: Determine the left and right sides of the machine
from the normal operating position.
1
Installing and Adjusting the
Handle
Parts needed for this procedure:
1 Handle
2 Cable tie

Installing the Handle

1. Remove the bolts, locknuts, and washers securing the
bottom of the handle arms to each side of the mower
(Figure 2).
Description
Handle
Cable tie
Kickstand assembly
Spring
Wheel shaft, right
Wheel shaft, left
Transport wheels (optional)
No parts required
Grass basket
Qty.
1
2
1
1
1
1
2
–
1
Qty.
1
1
1 Read or view before operating the machine
1
1
1
2
3
4
1. Handle arms
2. Mounting pins
2. Remove the hairpin cotters and ring pins securing the
handle arms to the rear of the frame (Figure 2).
3. Insert the handle ends through the holes in the handle
arms and align the holes with the mounting pins
(Figure 2).
9
Use
Install the handle.
Install the kickstand.
Install the transport wheel shafts.
Install the transport wheels (optional).
Adjust the cutting unit.
Install the grass basket.
Use
Figure 2
3. Bolt, locknut and washer
4. Hairpin cotter and ring pin
g021285