Installing And Adjusting The Handle - Toro 04036 Operator's Manual

1
Installing and Adjusting the
Handle
Parts needed for this procedure:
1 Handle
2 Cable tie
Installing the Handle
1. Remove the bolt, washer, and lockwasher from the
mounting pin on each side of the mower (Figure 2).
1. Mounting pins
2. Handle arms
2. Remove the bolts and locknuts securing the bottom
of the handle arms to each side of the mower
(Figure 2).
3. Remove the hairpin cotters and ring pins securing
the handle arms to the rear of the frame (Figure 2).
4. Insert the handle ends thru the holes in the handle
arms and align the holes with the mounting pins
(Figure 2).
5. Squeeze the handle ends inward and install them on
the mounting pins (Figure 3).
Figure 2
3. Bolt and locknut
4. Hairpin cotter and ring pin
1. Handle end
6. Secure the handle ends to the mounting pins with the
bolts, washers, and lockwashers previously removed
(Figure 3).
7. Secure the bottom of handle arms to each side of
the mower with the bolts and locknuts previously
removed (Figure 3). Ensure that you install the
bushings in the handle arm mounting holes.
8. Secure the handle arms to the rear of the frame with
the hairpin cotters and ring pins previously removed
(Figure 3).
Adjusting the Handle
1. Remove the hairpin cotters from the ring pins on
each side of the mower (Figure 2).
2. While supporting the handle, remove the ring pins
from each side and raise or lower the handle to the
desired operating position (Figure 2).
3. Install the ring pins and hairpin cotters.
10
Figure 3