Operating Panel Layout - Toshiba VFS5 Series Operation Manual

RUN lamp: When lit the drive
is running.
VEC lamp: When lit the system
is running in the vector
operation control mode.
ECN lamp: When lit the system
is running in the economy
( energy saving ) mode.
RUN key lamp: When lit the
RUN key can be used.
RUN key: To start operation,
press this key while the RUN
key lamp is on.
STOP key: Press this key to
stop operation.
TOSHIBA

Operating Panel Layout

CHARGE lamp: This lamp
indicates that the internal circuits
of the drive are charged with
high voltages. When lit, do not
open the terminal block cover.
UP key
DOWN key
UP and DOWN keys: Press
these keys to increase or
decrease the frequency during
operation.
24
Display unit: The operating freq,
parameters, faults, etc. are
displayed on the LED display.
MON lamp: When lit, the display
unit is in monitor mode.
PRG lamp: When lit, the display
unit is in parameter setting mode.
Built-in potentiometer lamp:
When lit, the operation frequency
can be set with the built-in
potentiometer
Built-in potentiometer: When the
potentiometer lamp is lit, the
operation frequency can be set
with this control.
ENT (enter) key
MON (monitor) key