Troubleshooting Chart - Champion TRISYS SSG M3 Installation, Operation, And Cleaning

Troubleshooting Chart

PROBLEM
Grinder and/or centrifuge is
jammed and/or overloaded with
waste.
Will not come on.
Low or no water in the
recirculation
tank.
Recirculation tank overflows.
Fills constantly.
Will not Drain.
Green pushbutton flashing.
Green pushbutton solid green,
not running.
Red pushbutton is flashing.
Red pushbutton is solid red.
Waste pulp is too wet or water
is exiting the discharge chute.
Odor is detected around machine. Improper cleaning of machine.
32
CAUSE
Improper loading of waste and/or
the loading prohibited materials.
Main power OFF.
Green start button not pressed.
Water supply OFF.
Drain open
Lower float dirty.
Defective lower float.
Slurry pump is clogged.
Defective fill valve.
Defective or dirty upper float.
Recirculation pump clogged or
defective.
Defective upper float.
Defective solenoid valve.
Drain valve(s) closed.
Building drain clogged.
Is machine filling with status window
display "FILLING"?
Does status window display
"CLEAN".
Does status window display
"READY"?
Does status window display "E-Stop"
Does status window display "Door
Open"?
Does status window display "Cfuge
OL", "Slurry OL", "Grinder OL", or
"Recirc OL"?
Food waste has insufficient mass.
Excess water in the system.
Improper cleaning of area around
machine.
SOLUTION
Follow the waste loading instructions.
Contact service agent for repairs.
Turn power on at main breaker.
Press start button.
Open supply valve(s).
Close drain.
Turn off power and clean float.
Replace float.
Call service agent.
Repair or replace the valve.
Clean or replace float.
Contact service agent.
Turn off power and clean float.
Repair or replace float.
Open drain valve(s).
Clean drain lines.
Normal - push green button to
start.
Normal - push green button when
status window displays "READY"
Normal condition, push green
start button to start.
Normal condition - see pg. 10 to reset.
Normal condition - close the grinder
access door.
Motor overload has tripped - turn
power off and call service agent.
Add small pieces of cardboard to
grinder.
Contact service agent to adjust.
Clean machine and surrounding area.
Refer to cleaning instructions.