Table of Contents
Advertisement
Operation
Run Mode - Balancing the System
•
Slurry pump turns off if pressure switch has NOT been made for 10 seconds.
•
Slurry pump remains off until pressure switch is made.
•
When pressure switch is made for 10 sec. and the waterpress middle float has
NOT been made for 10 secs:
a) slurry pump and recirc pump turn off
b) slurry pump restarts after 3 secs.
c) recirc pump restarts when waterpress middle float is made
•
The following happen simultaneously when the pressure switch is made for 15
secs. and the waterpress upper float is made:
a) recirc pump turns off until the pressure switch is not made for 3 secs.
b) automatic drain valve opens until the pressure switch is not made for 3 secs.
Run Mode - Processing Waste
•
WASTE LOAD MUST BE 70% FOOD AND 30% PAPER.
WARNING:
Do not load flatware, service ware, plastics, large bones, raw bones, (shells:
clam, oyster, mussel, shrimp, crab, lobster, scallop, walnut, peanut, pecan,
almond, or any other type of shell not listed), wood, or rags. Do not dump bulk
quantities from tubs, garbage cans, or other large containers directly into the
machine or feed troughs.
•
Ensure all access doors are closed.
•
Ensure a waste container is positioned underneath the discharge chute.
•
Load food waste, paper, and reduced cardboard into the waste trough.
•
The waste water will turn a milky color.
•
A wet pulp will begin to appear around the waterpress screen.
•
A semi-dry pulp will begin to exit the waterpress discharge chute.
NOTE:
The amount and consistancy of the discharge depends upon the waste
being fed into the system.
20
(continued)
Advertisement
Table of Contents
