Cleaning
Clean Mode
CAUTION:
DO NOT ADD WASTE TO THE SYSTEM DURING THE CLEAN MODE.
•
The HMI shows 'RUNNING'. The green start/stop station button is solid green.
•
Push the red start/stop station button. All motors stop.
•
The green start/stop station button begins to flash.
•
The automatic drain valve opens until the lower float drops out.
•
The drain valve closes/fill valve comes on.
•
Fills until upper float is made.
•
System runs for 10 secs.
•
The waterpress drains and fill three times.
•
The HMI shows 'CLEAN' for 10 minutes (seconds remaining is displayed on HMI).
•
Clean mode stops.
•
HMI shows 'READY'.
•
Green start/stop station button is solid green.
•
The automatic drain valve remains open for 10 minutes.
PRESS STOP FOR CLEAN
RUNNING
I/O
I/O
CLEAN
600
Continued on next page.
Cleaning
21