Replace Water Filter Standby; Important Information About The Aqua Prima Filter - Saeco RI9722/11 Service Manual

INCANTO S-CLASS
Replace water filter
Standby

Important information about the Aqua Prima filter

1. Store the Aqua Prima filter in a cool place, protected from sunlight. The room temperature must
be between +5°C and +40°C.
2. Use the filter in rooms where the temperature does not exceed 60°C.
3. We recommend washing the Aqua Prima filter when the coffee machine has not been used for 3
days.
4. If the coffee machine has not been used for 20 days, we recommend replacing the filter.
5. Store unpacked filters in an airtight nylon bag and place in a refrigerator. Do not place the filter
in the freezer as this will change the filter's characteristics.
6. Immerse the filter in the water tank 30 minutes before use.
7. Once the packaging has been opened, do not store the filter without any wrapping.
8. The filter must be replaced 90 days after unwrapping or after processing 60 litres of drinking
water.
Fault
The machine does not switch
on.
The coffee is not hot enough.
Only hot water is dispensed
when powder coffee is
selected.
No hot water or steam.
Machine heating takes a long
time.
The brewing unit cannot be
removed.
Coffee dispensing insufficient
or absent.
Saeco International Group
Replace the Aqua Prima filter as soon as possible.
If a new filter is not available, remove the current filter and turn
off the Water Filter function (see Programming).
Troubleshooting
Cause
The machine is not connected to the
mains power supply.
The cups are cold.
A low temperature has been set.
No powder coffee has been filled.
The nozzle is obstructed.
The machine is heavily calcified.
The brewing unit has stopped in an
incorrect position.
Grind too fine.
SBS is set to the right side.
REV.1 FEB.2005
3. OPERATION
Remedy
Turn on main switch.
Check plug and connection.
Pre-heat cups.
Set the machine to a higher
temperature.
Fill powder coffee and start
once again.
Clean nozzle out with
needle.
Dial is closed!
The machine is switched
off!
Descale the machine.
Close doors and switch on
the machine.
The machine performs a re-
positioning.
Set grind to higher level.
Turn knob in clockwise
direction.
Turn SBS knob to the left.
Page 13/21