Table of Contents
Advertisement
INCANTO S-CLASS
Fault/Indicator
Does not function
BREWING UNIT NOT
DETECTED
GRINDS CONTAINER
NOT DETECTED
EMPTY GRINDS
CONTAINER
COFFEE BEAN
CONTAINER EMPTY
FILL WATER TANK.
GRINDER OBSTRUCTED
DE-AERATE
REPLACE WATER
FILTER
Instead of coffee, only water
is dispensed.
No water / steam
The coffee flows too quickly
The coffee flows too slowly
Coffee is not hot enough
Coffee has no froth.
Longer heating time or less
hot water.
The brewing unit cannot be
removed.
Saeco International Group
Troubleshooting
Possible cause
No power
Brewing unit not properly installed
or not closed.
Coffee grinds container not properly
installed.
Coffee grinds container full
Coffee bean container is empty.
Water tank is empty.
Air in water system.
Coffee powder selection button is
pressed, but no coffee powder is
dispensed.
Steam nozzle blocked.
Beans ground too coarsely.
Beans ground too finely.
The cups are cold.
Boiler temperature too low.
Unsuitable coffee blend.
Coffee is no longer freshly roasted.
Beans ground too coarsely or finely.
The machine is calcified.
The brewing unit is not in home
position.
REV.1 FEB.2005
3. OPERATION
Remedy
Check mains plug / mains
circuit breaker.
Ensure machine door is
closed.
Install brewing unit
correctly.
Brewing unit correctly
installed.
Empty coffee grinds
container (reset only
possible if machine is turned
on)
Fill coffee container.
Fill water tank
Clean grinder.
Open water nozzle.
Replace water filter + reset
user menu
Add one level measure of
coffee powder.
Free opening using a thin
needle.
Press knob and turn in the
direction of the small points.
Press knob and turn in the
direction of the large points.
Pre-heat cups.
Increase temperature in user
programme.
Change brand of coffee.
Use fresh coffee.
Change grinding level.
Decalcify machine.
Turn machine on, close
service door and check
dregs drawer.
(the brewing unit goes
automatically to home
position)
Page 19/21
Advertisement
Table of Contents
