Table of Contents
Advertisement
INCANTO S-CLASS
Display in test mode:
123456789A MR (X)*
123456
Upper display line:
Indicates the status of the microswitch (see table).
Lower display line:
Indicates the status of the operating buttons.
Flow rate
If the pump is activated during test mode and the hot water valve opened, a two-digit number
appears on the bottom right side indicating the flow rate. This value must be between 40 - 60
(should not be below 40).
Grinder power
When the grinder is activated, the grinder power is indicated instead of the flow quantity. Set
value: 6-12
Dose quantity base adjustment (X):
A single digit number (X) appears to the extreme right in the top display line. This number
indicates the current dose quantity basic setting. The dose quantity base setting can be set at
three levels 0,1 and 2.
Aroma pre-selection
Dose quantity base setting
0
Dose quantity base setting
1
Dose quantity base setting
2
Programming: Press S2 (coffee button) and S6 (menu button) simultaneously. An asterisk
Memorise: S3 (expresso lungo) and S6 (menu button).
All CPU input signals from the machine appear in the first line of the display.
1 = Brewing unit in brewing position (brewing position microswitch activated)
2 = Brewing unit in at-rest position (idle position microswitch activated)
3 = Not allocated
4 = HWS valve microswitch activated
5 = Grinds container microswitch activated
6 = Brewing unit microswitch activated
7 = Water tank full (reed contact not activated)
Saeco International Group
xx
appears next to the number (x). Press the S2 button repeatedly whilst
keeping the S6 button pressed to change the base settings (see table).
REV.1 FEB.2005
5. SERVICE PROGRAMME
Mild
NORMAL
90
100
95
105
100
110
STRONG
110
115
120
Page 13/18
Advertisement
Table of Contents
