Table of Contents
Advertisement
E N
3. Mounting the charger
1.
Connect the charging plug to the plug holder.
2.
Verify the release button is well connected (see picture 3.0).
3.
Roll the hose around the plug holder (see picture 3. 1 ).
Good connection
(Green OK text visible)
Bad connection
(red area visible)
Picture 3.0
4.
Hold the charger using one hand at the upper corner and the other on the lower, opposite corner. (see
picture 3.2).
5.
Approach the charger to the wallplate, straightforward fixing the connector box to its charger coun-
terpart
6.
Secure the device to the wallplate, by fixing it to the support (see picture 3.3)
7.
Screw it on both sides using the four 5x10 screws (see picture 3.4)
Picture 3.2
14
Plug holder
Charging
plug
Picture 3. 1
Support point
Picture 3.3
Hose
Release button
Picture 3.4
Advertisement
Table of Contents
