Table of Contents
Advertisement
Access to Ports and Current Selector
Before proceeding, switch of the power supply and check no voltage is present at the
power cables.
Open the connection lid which is situated at the lower side of
the charger, remove its two screw for do it so.
Current selector
Use the selector to set the maximum current of the device. Positions 0, 8 and 9 are reserved for the Power
Sharing Smart feature (see "Power Sharing Smart" section for more details).
0
1
2
POSITION
CURRENT (A)
0
6
10
Ethernet connection
The charger can be connected to the using a built-in Ethernet port
Step 1: Insert the Ethernet cable without the RJ45 connector through the sealing grommet of the connec-
tion lid.
Step 2: Crimp the RJ45 connector to the cable.
Step 3: Connect the cable to the Ethernet port.
CAUTION: Inserting the RJ45 connector directly through the sealing grommet will result in
a loss of the waterproofing of the charger and its warranty.
Vehicle to grid configuration
If your charger is going to use the V2G or zero consumption features, please be sure you have the
instructions to perform this installation. In case of any doubt contact your sales agent.
3
4
5
6
7
8
9
13
16
20
25
32
0
0
Ethernet port
Connection lid
15
Advertisement
Table of Contents
