Dimensions And Positioning Of The Device; Drill; Mounting - Wallbox Pulsar Installation Manual

Dimensions and Positioning of the Device

In accordance with the product standards, the charging station must be located at height "y" (I-5)
between 1.3 m and 1.7 m above ground level.
station at a height of
mandatory to consider the following precautions:
• T
he mounting area required for the Wallbox charging station is at least 250x150 mm (height by
width) (I-5).
•
When installing the Wallbox, the cable should easily reach the vehicle inlet.
•
For a safe operation of your charging station, you must observe the minimum distances
recommended to other technical installations.
•
The plug holder (I-2) should be placed at a height between 0.50 m and 1.50 m. Maintaining a
square of 400x400 mm around it to provide sufficient space for the ergonomics is recommended.
Correct installation is absolutely essential and is outside the scope of the liability of Wallbox

Drill

Use the drilling template as a guide to mark the place for the three anchor screws on the wall. Take
special care to keep the template level. The use of a spirit level is highly recommended.
Drill the anchor hole marks to the diameter specified for the selected equipment for the installation. For
installation on wood, brick and concrete walls use the equipment delivered with the charger.

Mounting

1. OPENING THE DEVICE (I-6.1, I-6.2)
• Step 1.1. Remove the screw on the bottom side.
• Step 1.2. Carefully open the cover with the opening tool included.
• Step 1.3. Remove the ribbon cable from the cover.
2. CURRENT SELECTOR (I-7)
Use the selector to select the maximum input current of the device. Positions 0, 8 and 9 are
reserved for the Power Sharing Smart feature.
3. ELECTRICAL CONNECTION
I
MPORTANT: Always use standard cables that can drive the current that has
been setup in the current selector.
In the case that your Wallbox uses the rear input cable follow the steps in section
3-A. Otherwise go to section 3-B.
3-A. REAR CONNECTION
• Step 3-A.1: In the back of your Wallbox an area with a thinner wall can be found; use a cutter or any
sharp tool and make an incision for entry of the cable.
• Step 3-A.2: Carefully and firmly insert the power cable through the board. The board has been
designed so cables from 11 to 17 mm can pass through it, which is the standard for cables that can
drive up to 22 kW.
• Step 3-A.3: Proceed to fix the charger to the wall. Insert the screws in the marked positions,
starting at the top and following a clockwise direction (I-8.1). Check that your Wallbox
Pulsar is firmly fixed to the wall.
• Step 3-A.4: Make sure the previous steps have been completed correctly.
en
m. Remember that local regulations may limit this height. It is
1.4
Installation video available at https://wallbox.com
Make sure the power supply is turned off during all mounting steps
We recommend mounting the charging
7