Replacement Procedures
3. Set the TP button module on TP Bracket firmly. Make sure the guide pin (on TP
Bracket) insert into guide hole (on TP button module) properly.
4. Confirm the anti- "TP Button mis-action" structure also assemble properly
5. Secure the TP button module with the following screws.
• M2.0×2.5-I (BNI)(NYLOK) D7 T0.3 IRON Screw
Guiding Structure
Figure 4-16-6 Secure the TP button module with screws
6. Connect the TPB-TP FFC cable on the TP side.
7. Connect the TPB-MB FFC cable on the MB side.
Note:
Touchpad bracket could be reused after disassemble
Satellite L830 Maintenance Manual (960-Q08)
Figure 4-16-7 install touchpad module
anti- "TP Button mis-
action" structure
x3
50