Table of Contents
Advertisement
DRUM REPLACEMENT
Unplug unit before replacing drum.
REMOVAL
1. Unplug Contour SCT from power supply
before beginning.
2. Depress the Drive Lock Button on the left
side of the gearcase (FIG 2).
3. Place the included 8mm Hex Key Wrench into
the Socket Head Cap Screw on the right side
of the Drive Armature (FIG 3).
IMPORTANT NOTE: This is a left hand
thread, rotate in a Clockwise direction
to loosen.
4. Pull the Drum outward to remove from the
Drive Armature.
NOTE: A gentle pry with a screwdriver may
be required to release the Drum.
INSTALLATION
1. Align 2 of the 4 internal splines of the Drum
with the 2 Keys of the Drive Armature and
slide it on. NOTE: The face of the Drum
should be flush with the outer end of the
Drive Armature when fully seated (FIG 4).
2. Replace the M8 Socket Head Cap Screw and
Washer by threading into the right side of the
Drive Armature.
IMPORTANT NOTE: This is a left hand
thread, rotate in a Counter-clockwise
direction to tighten.
Never operate unit with Drum removed.
Severe injury could occur.
8
Eastwood Technical Assistance: 800.343.9353 >> techelp@eastwood.com
FIG. 2
Drive Lock Button
FIG. 3
Left-Hand Thread
Socket Head Cap Screw
FIG. 4
Drum
Drive
Splines
Armature
Drive
Keys
Hide quick links:
Advertisement
Table of Contents
